Resources

# Guides and how it works

The full method, explained the way a crew would explain it to an engineer.

These guides explain how each outside plant method is actually performed: the pilot bore and pullback sequence in directional drilling, field fusion splicing, strand and lash aerial construction, emergency fiber restoration, and the full project process from locate through closeout.

- [How Directional Drilling Works for Fiber ProjectsHorizontal directional drilling installs conduit or cable along a designed underground path without open trenching. A steerable drill head bores a pilot hole while a tracking system verifies depth and position. The hole is then enlarged by reaming, and the product is pulled back through it under controlled tension with drilling fluid lubricating the annulus.15 min read](https://strillacommunications.com/resources/guides/how-directional-drilling-works)
- [How Fiber Splicing Is Performed in the FieldFiber splicing joins two optical fibers into a continuous path. In the field this means opening the cable sheath, cleaning and cleaving each fiber, fusing the ends with an electric arc, protecting the joint in a sleeve, routing it into a tray, and verifying the result with an OTDR before the enclosure is sealed.15 min read](https://strillacommunications.com/resources/guides/how-fiber-splicing-is-performed)
- [How Aerial Cable Construction WorksAerial cable construction places fiber on existing utility poles. A steel messenger strand is installed and tensioned first, then fiber is lashed to it with a spinning lasher. The work depends on make-ready being complete, on holding NESC clearances over roads and driveways, and on sag being set for the span and temperature.15 min read](https://strillacommunications.com/resources/guides/how-aerial-cable-construction-works)
- [How Emergency Fiber Restoration WorksEmergency fiber restoration follows a fixed sequence: confirm the outage, locate the fault with an OTDR from both ends, gain safe access to the site, place a temporary or permanent repair, verify the segment against its baseline, and document what happened. Speed comes from preparation and accurate records, not from rushing the splice.14 min read](https://strillacommunications.com/resources/guides/how-emergency-restoration-works)
- [The Full Fiber Construction Project ProcessA fiber construction project runs in stages: scope walkout, design and permit coordination, make-ready or locates, mobilization, physical construction, splicing and testing, surface restoration, as-built documentation, and closeout. The construction itself is rarely the long pole. Approvals, make-ready, and material lead times decide the schedule, so they are tracked as milestones of their own.14 min read](https://strillacommunications.com/resources/guides/full-project-process-overview)

---
Source: https://strillacommunications.com/resources/guides